Heidenhain SHB Data Interfaces for HEIDENHAIN Manual de usuario Pagina 86

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 85
April 2010 8 – 87
8.1.3 Error messages at the FE in the ME mode
In the ME mode, errors are displayed by the indicator lamps (LEDs) of the control buttons
blinking.
LED off
LED on
LED blinks
Indicator lamps Error message


Disk is missing or error in the electronics


Disk cannot be formatted, as it is currently being used


Disk is missing or not formatted


Disk cannot be copied, as a read/write process is active


External device not ready or not connected


Disk is missing or not formatted


Disk is missing or not formatted or no program is available


Program cannot be output, as data transfer via the TNC interface is in
process


Program cannot be output, as data transfer via the PRT interface is in
process


External device not ready or not connected


Disk is missing or not formatted


Disk is missing or not formatted


Program cannot be output, as data transfer via the TNC interface is in
process


Program cannot be output, as data transfer via the PRT interface is in
process


External device not ready or not connected


Disk is missing or error in the electronics


Table of contents cannot be output, as data transfer via the PRT interface
is in process.
Vista de pagina 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Comentarios a estos manuales

Sin comentarios