Heidenhain TNC 620 (34056x-04) Cycle programming Manual de usuario descargar pdf (Pagina 305)

Fundamentals 15.1

15

TNC 620 | User's Manual Cycle Programming | 5/2013

305

Cycle Soft key Page

408 SLOT CENTER REF PT.

Measuring the inside width of a slot,

and defining the slot center as datum

308

409 RIDGE CENTER REF PT.

Measuring the outside width of a

ridge, and defining the ridge center

as datum

312

410 DATUM INSIDE RECTANGLE

Measuring the inside length and

width of a rectangle, and defining the

center as datum

315

411 DATUM OUTSIDE RECTANGLE

Measuring the outside length and

width of a rectangle, and defining the

center as datum

319

412 DATUM INSIDE CIRCLE

Measuring any four points on the

inside of a circle, and defining the

center as datum

323

413 DATUM OUTSIDE CIRCLE

Measuring any four points on the

outside of a circle, and defining the

center as datum

328

414 DATUM OUTSIDE CORNER

Measuring two lines from the

outside of the angle, and defining the

intersection as datum

332

415 DATUM INSIDE CORNER

Measuring two lines from within the

angle, and defining the intersection

as datum

336

416 DATUM CIRCLE CENTER

(2nd soft-key level) Measuring any

three holes on a bolt hole circle,

and defining the bolt-hole center as

datum

339

417 DATUM IN TS AXIS

(2nd soft-key level) Measuring any

position in the touch probe axis and

defining it as datum

343

418 DATUM FROM 4 HOLES

(2nd soft-key level) Measuring 4

holes crosswise and defining the

intersection of the lines between

them as datum

345

419 DATUM IN ONE AXIS

(2nd soft-key row) Measuring any

position in any axis and defining it as

datum

349

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 467 468

Comentarios a estos manuales

Sin comentarios